A selection of PVC Battery Wraps, sold individually, in the case where your battery wrap has been damaged and you want to patch it up with a fresh coat.
Why would I want one of these?
These battery wraps are pre-cut, with about half an inch give for an 18650 battery. To apply the wrap, sleeve it over the battery, trim it down to about 3mm excess on the bottom and top of the battery, and use very light indirect heat such as a hairdryer (on low setting) heat-shrink gun, or careful use of a lighter to indirectly fan warmth over the top and bottom, if done properly it will tighten nicely over the battery.
PVC 18650 Battery Wrap
Tip, use the thinnest paper you can find for your prints to put under these wraps, it's a tight fit.
Worked great and easy enough to install. Made my old batteries look new again.
Easy to use. I did it with a hair dryer and was surprised at how well it turned out. I would recommend! I rewrapped 8 of my batts.
Your battery wraps worked great on my 18650's. Perfect length, required no trimming. I used a heat gun to shrink them.